Bischoff & Bischoff Eltego, Инструкция по эксплуатации

Страница: 8 / 19

Bischoff & Bischoff GmbH | 14.02.2020
EN
15 14
Eltego | Electric Wheelchair Electric Wheelchair | Eltego
3.5.6. Side Parts
You can slide the side parts sideways.
• Loosen the fastening (SW 13) below the seat and slide the side part
into the desired position.
• Tighten the fastening again.
Make sure the fastening is firmly tightened.
3.5.7. Control unit
The control unit can be mounted either on the right or left-hand side
underneath the armrest each.
• The control unit must be adjusted by a qualified mobility dealer to
warrant safe functionality of the wheelchair.
Adjusting the height
• The distance to the armrest can be adjusted.
• Loosen the screw connection on the inner side of the side part.
(Fig. 10)
• Move the control unit into the desired position, then tighten the
screw again.
Distance from the armrest
• You can adjust the position of the control unit to your forearm
length.
• Loosen the hand screw on the outer side of the side part. (Fig. 11)
• Move the control unit into the desired position, then tighten the
screw again.
Don’t forget that the cables to the control unit have
to be repositioned. This should be done by a quali-
fied mobility dealer.
3.5.8. Seatbelt
The seatbelt is attached to the side of the backrest.
• Adjust the length of the seatbelt by positioning the buckle
accordingly.
• Fasten the seatbelt with the latch.
• Open the seatbelt by pushing the red button at the latch.
10
11
12
08
09