Installation
5
Interlock Connection
1.
Unscrew the large knurled ring-nut (A) at the lower end of the coupling jack assembly.
2.
Pull it off the thermoswitch jack (B).
3.
Unscrew the small knurled cover fitting from the base plug (D) of the connector to release the base.
4.
Thread the control switch wires through the clamp (E) with the washers (F) inside and with its threaded fitting
in place.
5.
Service the control switch wire with short tips.
6.
Put spaghetti sleeves over the wire ends if necessary.
7.
Securely solder the control switch leads to the lugs (G) of the connector base.
Note:
The ring-nut (A) must be in place over the base plug (D) with the knurled end facing out.
8.
Screw on the cover ring.
9.
Fasten the cable clamp (E) in place.
10. Tighten both yoke screws (H).
11. Put the plug back on the thermoswitch and tighten the nut (A).
Figure
2
Thermoswitch
Assembly
CAUTION
If installed, connect optional interlock before applying RF power.
