Ethernet Model Pulse Sensor
9
Installing the 7027 Ethernet Model Pulse Power Sensor
WARNING
Never attempt to connect or disconnect RF equipment from the transmission
line while RF power is being applied.
Leaking RF energy is a potential health hazard.
1.
Insert the 7027 Power Sensor into a coaxial transmission line of 50 ohms
nominal impedance.
Note:
Connect the
7027
Power Sensor to the RF line so that the
arrow on the sensor points towards the load.
2.
Connect an Ethernet cable to the PC.
3.
Connect the remaining end of the Ethernet cable to the power sensor.
4.
Connect the 5 VDC Power supply output to the power input connector on
the Power Sensor.
5.
If an external sync pulse signal will be used, connect the BNC plug on the
sync pulse input cable to the BNC connector in the bottom of the sensor.
6.
Refer to the 7027 SCPI programming manual for control and monitoring of
the Pulse Power Sensor.
