1
Chapter 1
Installation Instructions
Kit Contents
Panel Assembly
Rack Mount 6-054 Panel
PC Board Assembly
Brass - Nickel Plated Spacer
PC Board Cover
Zinc Handle
Interface Latch-N-Lok Cable
Installing the Panel Mount
1.
Remove the four button head screws (A).
2.
Move front panel (B) away from bezel (F).
3.
Disconnect ribbon cable (C), hex nut (L), washer and green ground wire (D).
4.
Remove front panel (B).
5.
Remove four Phillips Head screws (E).
6.
Remove bezel (F).
7.
Align four mounting holes in rack panel (G) to four mounting holes in bezel (F).
8.
Using the four Phillips Head screws (E), attach rack panel (G) and bezel (F) to the original mounting holes in the
frame.
Note:
Reverse remainder of procedure for reassembly.
9.
Connect interface cable (H) to rear of unit.
10. Connect opposite end to connector box on rack panel (G).
11. Remove of handle (M).
12. Remove the two buttons (I).
13. Remove the hardware and handle (J thru Q).
14. Place interface cable (H) in handle slot.
Note:
To ensure proper installation, the interface cable should not hang below bottom edge of panel.
Note:
Interface cable should be pressed into handle slot on side of case.
