BIRD 428B-83H-01-C-110, Инструкция по установке и эксплуатации

Страница: 54 / 60

TX RX Systems Inc. Manual 7-9487-3 05/05/11 Page 46
SNMP SUPPORT DISABLED
This will prevent unauthorized SNMP access. If
SNMP is required to be used for network manage-
ment, this will need to be re-enabled and setup as
desired by your network administrator
.
TELNET SECURITY
A factory default Telnet password has been added
to deter anyone from accessing the product
through the Telnet port without proper authoriza-
tion. It is recommended that the user concerned
with high security should change this to a pass-
word of choice. The procedure for doing this is
explained in the next section.
Changing The Telnet Port Password
To change the Telnet port password perform the
following steps;
1) Launch HyperTerm on your direct connected
laptop or your remote PC.
2) Navigate to the Change Setup Menu by follow-
ing steps 4 through 8 as discussed in the earlier
section of this appendix (Networked Connec-
tion).
3) At the fourth query in the Server menu “Change
telnet config password (N)” type-in “Y” for yes
and you will be prompted to enter the new pass-
word. Refer to
Figure A9 .
The password is factory limited to
four characters.
4) Type-in the four characters of the new pass-
word and you will automatically return to the
Change Setup Menu.
5) To finalize your password change choose (9) to
save the new information and exit the Change
Setup Menu. Close the Hyperterm utility pro-
gram.
It is suggested to keep note of this
password change in order to pre-
vent an issue with future connec-
tions through Telnet.
NOTE
NOTE
Figure A9: Changing the Telnet Port Password.