PRIOR TO INSTALLATION
Your complete Super Broadband Pro kit includes a
control unit, power adapter and four speakers.
Open the control unit by lifting the two latches on the
side of the enclosure.
Prior to operation, route the speakers and power
cables from their respective jacks on the control
panel down through the cable strain relief in the
lower part of the enclosure, as shown in Figure 1.
IMPORTANT: Be certain that
the power switch is in the OFF
position and the volume control
is set to the minimum (LOW) -
volume level (counterclock-
wise) as shown in Fig. 2 while
plugging the speaker and power
cords into the control unit.
HOW IT WORKS
Sonic and ultrasonic sounds sequence through all
four speakers. Sonic sounds play according to the
programming options you choose. Ultrasonic
sounds are always active --day and night-- regard-
less of programming, however they won’t play
during
the sonic sounds.
INSTALLATION
1)
Use the mounting hardware (included) to mount
the control unit box to a wall, post or other vertical
surface.
Digital Bird Repeller
is not operating in the
Random Mode, the unit will
play the selected record-
ings in a sequential order.
The Random Mode is
recommended
to
keep
birds from adapting to a preset pattern of sounds.
To operate the unit in Random mode, set switch
5
in
Mode settings
as follows:
Switch 5
Mode
ON
RAMDOM (Mode ON)
OFF
NOT RANDOM (mode OFF)
ULTRASONIC FREQUENCY SWITCH
The ultrasonic sounds play regardless of the
other settings you choose. HIGH, MED and LOW
refer to the frequency of the ultrasonic sound
waves. We recommend you begin on LOW, and
then vary between the three every so often
(during routine maintenance, for example).
PROGRAMMING EXAMPLE
Recording Switches:
Results
1, 3, 5 and 6 to “ON” position
Plays Sound 1, 3, 5 & 6
Mode Switches
1 = “OFF” position
2 = “ON” position
(Medium), every 1 to 4 minutes
3 = “ON” position
4 = “OFF” position
Operates during daylight hours only
5 = “ON” position
In random, non-sequential order
VOLUME CONTROL
The unit has a volume control dial for the sonic
(audio) sounds on the front panel of the unit. Turn-
ing the dial toward low will result in reduced sound
output and rotating the dial toward high will result in
an increase in sound output.
CAUTION: Take care when turning the dial since the
unit may be in an inactive state when the dial is rotat-
ed. It could then reactivate at a very high level of
sound which could be painful to your ears.
POWER SWITCH
The power switch enables the unit to operate.
Slide the switch to the ON position to start the unit.
If you turn the unit OFF, be sure to leave it off for
about 30 seconds before turning it back on to allow
the electronics to properly reset.
PREVENTATIVE MAINTENANCE
Since 1967, our products have provided years of
trouble-free service with only a minimum of routine
maintenance. This unit is specifically designed for
extensive outdoor use and temperature extremes.
The electronic circuits inside the unit are coated for
oxidation and moisture protection and need no
maintenance. For the longest life of extermal com-
ponents, clean off any excess dirt or corrosion.
Twice a year, lubricate the switch sockets and the
connections with silicone spray.
TROUBLESHOOTING
300 North Elizabeth Street • Chicago, IL 60607
ph. (312) 226-2473 • fax (312) 226-2480
Toll Free US & Canada 800-662-5021
www.bird-x.com
EPA Establishment Number 075130-OR-001
Fig. 1
THIS SUPER BB PRO UNIT IS GUARANTEED
AGAINST DEFECTS IN MATERIAL AND WORKMAN-
SHIP FOR SIX MONTHS FROM DATE OF PURCHASE.
BIRD-X WILL REPLACE OR REPAIR, PROVIDED
DEFECT OCCURS UNDER NORMAL USE. UNITS
ALSO CARRY A 30-DAY PERFORMANCE GUARAN-
TEE. IF USER IS NOT SATISFIED WITH RESULTS,
UNIT MAY BE RETURNED WITHIN 30 DAYS FOR
CREDIT LESS A 15% HANDLING AND RESTOCKING
CHARGE.
RETURNS ACCEPTED ONLY WITH
AUTHORIZATION FROM OUR CHICAGO OFFICE.
Super Billboard PRO Instructions #655-0047-00
(rev. 2/19/03)
Cable Strain Relief
LIMITED WARRANTY
Super Broadband PRO
™
SUPER
BILLBOARD
PRO
8
1
2
3
4
5
DELAY
TIME
NOT RANDOM
PROBLEM
Unit is on, but no
sound is heard
Unit is on, but plays
the same bird over
and over, regardless
of settings
Unit is not operating
properly in the
DAY or NIGHT mode
• Check volume settings
• Check time of operation
settings.
• Check that at least one bird
is selected to play.
Reset the unit by turning
it off for 30 seconds and
then back on
• Double check Mode
switch settings
• Make sure photocell
is not obstructed.
• Make sure the photocell is
not affected by bright
lights in either the front
or the back of the unit.
PROBLEM SOLUTION
Fig
. 2
