Bird-X Mega Blaster PRO User
’
s Manual (#655-0065-00
–
May 2016)
8
Installation
Note: Foliage, trees, and other obstructions severely reduce the effective range of
Mega Blaster PRO units. It is critical that the 20-Speaker Tower is mounted at least 5
feet above all obstructions to achieve the maximum protection.
Mounting Pole or Mast
1. The Mounting Pole or Mast will need to be supported by a T-Post, fence post, tree or other means. The Pole Support
should be in place before proceeding.
20-Speaker Tower
2. Lay the 20-Speaker Tower on its side on the ground and cut the zip-tie
securing the speaker cables.
3. Slide the 1 in. (outside diameter) Mounting Pole through the Collar at
the bottom of the 20-Speaker Tower (Figure 4A) until it slides over the
positioning pin inside the top of the Tower (Figure 4B).
4. Tighten the Set Screw in Collar securely.
Solar Panel
5. With the glass side of the solar panel facing the 20-Speaker Tower, slide the U-Bolts in the Solar Panel Mounting
Bracket over the lower end of the Mounting Pole approximately three feet from the bottom of the pole and tighten the
U-Bolts (Figure 5).
6. Lean up the Mounting Pole with the 20-Speaker Tower on top, against the Pole Support and fasten the Mounting Pole
to the Pole Support securely with wire or other semi-permanent means.
7. Rotate the solar panel so it receives the most possible sunlight and tighten the Pivot Bolts so the panel is at
approximately 45 degrees.
Collar and Set Screw
Slide Mounting Pole all the way
through the 20-Speaker Tower
U-Bolts
Approximately 3 ft.
Figure 5
