BP-007 User’s Manual
- 50 -
FS
-
Set Chinese underline mode
Format: ASCII: FS
- n
Decimal: 28 45 n
Hex:
1C 2D n
[Description]
Turns on or off underline mode for Chinese characters, using n
as follows:
When n=0, underline has no effect on Chinese characters;
When n=1, Chinese characters are set by single underline mode;
When n=2, Chinese characters are set by double underline mode, but the shift generated by “HT”
command is invalid.
FS
2
Self-define Chinese characters
Format: ASCII: FS
2 a1 a2 d1 d2 d3 …d32
Decimal: 28 50 248 a2 d1 d2 d3 …d32
Hex: 1C 32 F8 a2 d1 d2 d3 d32
[Description]
Define the user-defined Chinese characters.
a1=F8 (Hex); A1
≤
a2
≤
FE (Hex).
Chinese code has two bytes: a1 is the first byte and a2 is the second byte.
FS
S
Set full-size Chinese characters spacing
Format: ASCII: FS
S n1 n2
Decimal: 28 83 n1
n2
Hex: 1C
53 n1
n2
[Description]
Set the left-side character spacing to n1 dots; Set the right-side character spacing to n2 dots. Half-size
characters will be put in good order automatically to ensure that the width of full-size character is twice that
of half-size character.
Default: n1=0, n2=2.
FS
W
Turn quadruple-size mode on/off for Chinese character
Format: ASCII: FS
W n
Decimal: 28 87
n
Hex: 1C
57
n
[Description]
Turn quadruple-size mode on or off for multi-byte code character.
When n
＝＜
*******1
＞
B, quadruple-size mode is turned on.
When n
＝＜
*******0
＞
B, quadruple-size mode is turned off.
GS
FF
Executes black mark detecting
Format: ASCII: GS
FF
Decimal: 29 12
Hex: 1D
0C
[Description]
Execute black mark detecting command. If black mark is detected, the printer stops feeding paper and
returns a value (AAH) by serial interface; If black mark is not detected, the printer feeds paper until to the
end of this page and returns a value (55H) by serial interface.
