Birch BD-408e, Руководства, Страница: 9 / 71

Q:Could I change scanner into different type interface directly?
A: You can change factory interface default for other type interface.
By plug different cable, program scanner and set right interface to
exit, then the scanner will be change to another interface.
However, you must make sure what cable you need. Refer Cable
Type to
/
66, 67.
Q: How to configure scanner via RS-232C?
A: Next to the selection description, you will find a frame command,
such as AAB. These commands can be sent to scanner with
RS-232C interface. You must make sure that scanner is the same
protocal as your equipment of RS-232C, and light source of
scanner has been actived by pressing button.
Example Beep Loudness Level "10", Good-read Beep "Enable"
T o configure the reguired commands proceed as follows:
Send as: <ESC>(1B
16
)
ï
Command(s)
ï
<CR>(0D
16
)
Send <ESC> ï BAC ï %01 ï %00 ï %OK ï CEB ï <CR>
︸ ︸ ︸ ︸ ︸
Beep 1 0 SET Good-read
Londness Level Beep Enable
*
Call to the dealer if scanner dose not work properly.
9
Introduction
1