3
Managing Basic PR
ON / OFF button
Press once to start the device. Note that it takes a few seconds before the
lamp indicator lights up. (The indicator is the small round window under the
logo. The lamp under the word "POWER" will illuminate when the device is
operating normally. When the lamp under the word "POWER" begins to turn
red, it is time to replace the UV lamp in the device.
Press once again and the unit goes to night mode, meaning it is still cleaning,
but all lights will go out. During night mode, however, the lamp under the word
"POWER" will flash. Press again to turn the device off completely.
Note that the lights on the display and under the log can be blue or green and
differ in strenght depending on the individual device. This does not effect the
capacity.
TIMER
You can set the device for 2, 4 or 8 hours. After the specified time, it will stop
until you set new time or turn it on for continuous operation. It goes
continuously when the lamp under "ON" lights up.
FAN SPEED - LOW, MED and HIGH
For example, use LOW in the bedroom for the least possible sound. Use MED
for continuous operation in larger rooms. Use HIGH if you burn something in
the oven or that something allergic is extra difficult for a while.
Maintenance
Basic PR requires only a minimal amount of maintenance. If the device is in a
very smokey or dusty environment we suggest you open the unit and clean the
UV lamp with a soft cloth using alcohol (every 3 months). NOTE! The device
should be unplugged and the lamp should be cold first. If you do not clean the
lamp, the cleaning effect is gradually reduced.
Adapter
The adapter comes with both EU and UK contact. If you need to change, push
down the small latch next to the power plug and turn counter clockwise until the
plug is unplugged. The new plug sits down into the hole and turns clockwise until
you hear that the connector clicks.
BioZone Portugal, Lubelias,
www.biozone.one, +351 92 422 98 45
