Biotek Synergy HTX, Руководство оператора

Страница: 107 / 184

Routine Procedure for Models with Injectors
|
85
Routine Procedure for Models with Injectors

Perform this Routine Procedure when all systems are functioning
normally on the Synergy HTX with Injectors. If you are unable to
prime the Synergy HTX due to a system failure, perform the
Alternate Procedure described on page 89.
If disinfecting with sodium hypochlorite (bleach), be sure to
flush repeatedly with deionized water to ensure that no bleach
is carried over. After disinfecting with sodium hypochlorite,
perform the rinse procedure provided on page 87.
If disinfecting with alcohol, do not immediately prime with
deionized water, because the drying effect of the alcohol is an
important aspect of its disinfectant properties.
Clean Exposed Surfaces
1.
Turn off and unplug the instrument.
2.
Prepare an aqueous solution of 0.50% sodium hypochlorite (bleach). As an
alternative, 70% isopropyl alcohol may be used if the effects of bleach are a
concern.

Be sure to check the percent NaClO of the bleach you are using; this
information is printed on the side of the bottle. Commercial bleach is
typically 10.0% NaClO; if this is the case, prepare a 1:20 dilution.
Household bleach is typically 5.0% NaClO; if this is the case, prepare
a 1:10 dilution.
3.
Manually open the plate carrier door; slide out the plate carrier.
4.
Moisten a cloth with the bleach solution or alcohol.
Do not soak the cloth.
5.
Wipe the plate carrier and the exposed surfaces of the external dispense
module.
6.
Wait 20 minutes. Moisten a cloth with deionized (DI) or distilled water and
wipe all surfaces that have been cleaned with the bleach solution or alcohol.
7.
Use a clean, dry cloth to dry all wet surfaces.
Synergy HTX Operator’s Manual