9
Define System Settings
The cabinet light can also be turned
OFF
. The light can
be independently adjusted between the two cabinets.
»
Alarm Volume:
The system will sound when an
evaporation run is completed or an error occurs. The
sound level can be set to
Low
,
Medium
,
High
, or
OFF
.
»
Temp Unit:
The temperature unit in use by the
system, degrees Celsius or Fahrenheit. Press
the button to change the temperature unit.
»
Screen Brightness:
The brightness level of the touch
screen. Press (–) or (+) to adjust the brightness.
1
Manifold
The selected/installed manifold. Press to
change manifold setup.
2
Cabinet Light
Cabinet light intensity. Press (–) or (+) to
change the light intensity.
3
Alarm Volume
The current and set alarm volume. Press to
change the alarm volume.
4
Temp Unit
The set temperature unit used by the system.
Press to switch between °C and °F.
5
Screen Brightness Brightness of the touch screen. Press (–) or
(+) to change the brightness.
Figure 11.
The Common Settings view.
Evaporation Settings
Enter the Evaporation Settings view (Figure 12) by pressing the
Evaporation Settings
button, see Figure 10.
Note:
The system cannot run at temperatures below the ambient
temperature.
The following settings can be configured:
»
Wait for gas temperature:
Tick the box to
wait for the gas temperature to reach the set
value before starting an evaporation.
»
Wait for plate temperature:
Tick the box to
wait for the plate temperature to reach the set
value before starting an evaporation.
»
Idle Heating:
Set the function behavior of the
system heaters for when no evaporation run is in
progress. Available settings are
Off
,
On
or
Auto
.
»
Off:
Heating is turned off.
»
On:
Enter desired values for gas and plate
preheating by pressing the buttons below.
»
Auto:
The system reuses the values for gas
and plate preheating from the previous
method or the last manual run.
»
System idle gas temperature:
Press the button
to set the system idle gas temperature.
»
System idle plate temperature:
Press the button
to set the system idle plate temperature.
1
Wait for gas
temperature
Tick the box to wait for the gas temperature
to reach the set temperature before starting
an evaporation.
2
Wait for plate
temperature
Tick the box to wait for the plate temperature
to reach the set temperature before starting
an evaporation.
3
Idle Heating
Mode
Set the idle gas and plate temperature
heating to
Off
,
On
or
Auto
4
System idle gas
temperature
The set system idle gas temperature in °C or
°F . Press to change the temperature.
5
System idle plate
temperature
The set system idle plate temperature in °C
or °F . Press to change the temperature.
Figure 12.
The Evaporation Settings view.
