K8VBK-S7 BIOS Setup
31
6.8 Modem Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices: 3
(default),4 / 5 / 7 / 9 / 10 / 11 / NA.
6.9 Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has “hung.”
6.10
Run VGABIOS if S3 Resume
Choosing Enabled will make BIOS run VGA BIOS to initialize the VGA card when system
wakes up from S3 state . The system time is shortened if you disable the function , but
system will need AGP driver to initialize the card . So , if the AGP driver of the VGA card
does not support the initialization feature , the display may work abnormally or not function
after S3 .
The Choices:
Auto,
Yes
(default), No.
The Choices:
Delay 4 Sec,
Instant-Off
(default).
6.11 AC LOSS AUTO RESTART
This field determines the action the system will automatically take when
power is restored to a system that had lost power previously without any
subsequent manual intervention. There are 3 sources that provide current
to the CMOS area that retains these Power-On instructions; the
motherboard battery (3V), the Power Supply (5VSB), and the Power
Supply (3.3V). While AC is not supplying power, the motherboard uses the
motherboard battery (3V). If AC power is supplied and the Power Supply is
not turned on, 5VSB from the Power Supply is used. When the Power
Supply is eventually turned on 3.3V from the Power Supply will be used.
There are 3 options: “Former-Sts”, “On”, “Off”.
“Off”
(default) Means always set CMOS to the “Off” status when AC
power is lost.
“On” Means always set CMOS to the “On” status when AC
power is lost
“Former-Sts” Means to maintain the last status of the CMOS when
AC power is lost.
For example: If set to “Former-Sts” and AC power is lost when system is
live, then after AC power is restored, the system will automatically power
on. If AC power is lost when system is not live, system will remain
powered off.
