MP30 Hardware Guide
-
5
-
•
The power supply requirements for the MP35/30 are 12 VDC @ 1 Amp. Only use the
AC300A power adapter with the MP35. The AC300A is a 12 VDC @ 1.25 Amp power
supply adapter that can connect to any mains rated as 100-250 VAC @ 50/60Hz, 40VA.
•
The receptacle is configured to accept a “+” (positive) input in the center of the connector and
a “-” (negative) input on the connector housing.
Fuse holder
The fuse holder contains a fast-blow fuse that helps protect the MP35/30 from shorts on its power,
analog, and digital I/O lines. The MP35 uses a 1.0 amp fast-blow fuse and the MP30 uses a 2.0 amp
fast-blow fuse.
•
To remove the fuse, use a screwdriver to remove the fuse cover located below the word Fuse.
Power switch
•
ON position — powers up the MP35/30
•
OFF position — cuts the flow of power to the MP35/30
CLEANING PROCEDURES
Be sure to unplug the power supply from the MP35/30 before cleaning. To clean the MP35/30, use a
damp, soft cloth. Abrasive cleaners are not recommended as they might damage the housing. Do not
immerse the MP35/30 or any of its components in water (or any other fluid) or expose to extreme
temperatures as this can damage the unit.
