Bioloid STEM, Руководство пользователя, Страница: 11 / 28

北京智能佳科技有限公司
The power does not turn on.
Is the battery properly connected?
Is the battery fully charged?
Is the battery fuse intact?
⇒ Please refer HERE for information on how to replace the fuse.
I want to check how much battery I have left.
Turn the CM-530 on and press the U button. The LED will turn on to show how much battery you
have left as seen in the figure below.
The robot makes a continuous warning sound while moving.
The alarm indicates that the robot is low on batteries. Immediately recharge your battery.
(Refer to Charging )
If you do not replace the battery right away, the robot may turn off without warning and fall,
which can cause severe damage.
Assembly Check
In Assembly Check mode you can verify whether your robot has been properly assembled.
Compare the initial position of the motors.
1. To run Assembly Check mode select ‘ Manage ’ , hold the ‘ D ’ button followed by
‘ START ’ .
→ Keep holding until melody finished playing.
2. Select the motor with either ‘ U ’ or ‘ D ’ buttons. The selected motor with turn its
LED on and position itself into its initial position.
→ ‘ U ’ ups ID order while ‘ D ’ downs ID order.