Biodom 27 d. o. o.
T: +386 8 205 10 86
OIC Hrpelje 4 a, 6240 Kozina
F: +386 5 662 67 57
www.biodom27.si
7
THE INSTALLER MUST
VERIFY (CONFIRM):
-
the type of furnace (that is being mounted);
-
the adequacy of the area, i.e. the size of the area that is need for installation, as indicated by the
manufacturer;
-
the instructions of the manufacturer, which provide information regarding the system requirements
for the exhaust (inlets and outlets for the exhaust system);
-
the inner cross section of the chimney duct, the materials used for the chimney, uniformity of the
cross section and any potential obstacles;
-
the consensus of a chimney-sweeping provider, if required by local legislation;
-
installation and adequacy of the chimney lid, which should be resistant to strong winds;
-
possibility of protecting the external air conduit as well as the size of any necessary openings;
-
possibility of simultaneous usage of the furnace, which needs to be installed with the remaining
equipment, already on location.
If all requirements are met, the installation of the furnace may proceed. Installation must adhere to the safety
instructions provided by the manufacturer.
AFTER INSTALLATION, THE SYSTEM MUST BE OPERATIONAL FOR AT LEAST 30 MINUTES, SO AS TO CHECK THE
SYSTEM'S SEALS.
After completing the installation, the installer must provide the customer with:
-
THE USAGE AND MAINTAINANCE MANUAL, ALSO PROVIDED BY THE MANUFACTURER (IF THE
MANUAL WAS NOT DELIVERED WITH THE FURNACE);
-
THE DOCUMENTATION NEEDED FOR COORDINATING THE FURNACE WITH THE APPLICABLE
STANDARDS.
2.0
INSTALLATION – FURNACE INSTALLATION
The user takes full responsibility for any work done on location.
Prior to starting the furnace, the installer must fulfil all applicable safety standards, as well as:
-
check that the furnace position corresponds to local, national and European standards;
-
ensure that the furnace complies with the requirements stated in this document;
-
ensure that the exhaust system and air conduits comply with the type of furnace;
-
ensure that no power supplies with temporary or non-isolated electrical flexes are established;
-
check the efficiency of the grounding;
-
ensure that the installer uses proper safety equipment and all required safety measure at all times.
AMPLE SERVICE SPACE (NEEDED FOR ANY MAINTAINANCE OR REPAIR WORK) SHOULD BE PROVIDED AT ALL
TIMES.