HOME anglais
Copyright BIO-UV
Page 5
B.
WARNINGS AND SAFETY
BIO-UV sterilizers are ready to install, no work is required inside the reactor.
READ ALL THE INSTRUCTIONS IN THIS MANUAL BEFORE SWITCHING ON THE
BIO-UV APPLIANCE.
INSTALLATION
RECOMMANDATIONS
The reactor must be installed in a technical room, protected from light and rain.
The reactor must be installed in a dry zone.
The installation zone temperature must be within 0°C and 40°C.
Ambient humidity must be < 80%.
Make sure you choose a position where the lamp can be taken out – the AVAILABLE HEIGHT should be
DOUBLE the total height of the appliance.
The sterilizer should be installed after the filter(s).
Keep any sources of hydrochloric acid vapours away from the installation.
●
The unit must be charged for installation.
We recommend the presence of a by-pass.
●
Before accessing the connection terminals, ensure that all supply circuits are
disconnected.
●
The reactor installation as a whole must be protected with a suitably adapted circuit
breaker. (See A. Technical characteristics)
●
Check that cable complies with legislation and the required power level.
(See A. Technical characteristics)
USE and MAINTENANCE:
●
The sterilizer must be turn on 24h/24 in order to disinfect the first liters of water at each
opening of tap.
●
Never look at the ultraviolet lamps when lit. This may cause severe injuries or burns
and may even lead to loss of eyesight.
●
Do not touch the ultraviolet lamp with bare hands, as these would leave impurities that
shorten the life of the lamp. If you do touch it: clean with alcohol or white vinegar.
●
Never unscrew the quartz tube sealing nut when the reactor is on load as the quartz
tube could be blown out of the reactor with force and injure you.
●
Do not use the reactor if the power supply wire is worn or damaged. In this case it should
be replaced.
●
Even when stopped, power is present in the electrical unit so make sure that the
main power supply upstream of the electrical cabinet is switched off before carrying out any
work on the equipment.
●
To avoid electric short-circuits, do not place the electric wires or the reactor in the pool
water or in any other maintenance or cleaning fluid.
●
Do not restart the system until the electric unit, the covers exterior elements of the
reactor are correctly back in place.
●
Do not use the BIO-UV reactor for any other use than that for which it was designed.
