HOME anglais
Copyright BIO-UV
Marque, Modèles et Brevets déposés - Produits exclusifs
Page 10
7
Insert a thumb or finger in the sleeve and gently
withdraw it until the O-ring comes free
from its housing.
8
Take hold of the quartz sleeve and extract it fully MAKING SURE that you keep it
correctly aligned with the axis.
9
Clean the quartz sleeve using acid or spirit vinegar or change it if necessary.
10
CAREFULLY insert the sleeve in the equipment,
keeping it correctly aligned with the axis.
11
With a finger inside the sleeve, position the quartz in its socket (15) at the bottom of
the equipment. The quartz should protrude slightly
(by the thickness of the O-ring),
it should not be dropped right to the bottom.
If the quartz is correctly positioned in the socket, when you press it, it feels flexible
(pneumatic effect).
12
Lubricate the new O-ring with edible fat.
(Put a new O-ring at each change of lamp)
Position the O-ring around the sleeve
and push it fully home in its housing using your nail (do not use tools).
13
Place the plastic washer inside the stainless steel thread.
Re-tighten the nut by hand, tightening it normally.
14
Put the installation back in pressure before the reassembly of lamps
and check that there is no leakage in the quartz tube.
15
Take hold of the new lamp taking care not to place your
fingers outside the cap.
(if you do, clean the lamp with a soft cloth and some
methylated spirits)
16
Engage the lamp in the quartz sleeve keeping it correctly aligned
with the axis inside the equipment.
17
After engaging it to the ¾ point, connect the 4-pin connector ensuring that it is the
right way round (locating pin).
Do not force.
18
Fully engage the lamp in the quartz sleeve.
19
Secure the 4-pin connector using the stainless steel nut.
20
Refit the cover.
