Start Up. Power up the iCycler using the power switch on the right rear of the
instrument. After a quick diagnostic routine, the Log In screen will be displayed.
Log in.
•
If you are registered user:
Press Enter, and select your name from the user list
•
If you are not yet a registered user:
Use the right arrow key to highlight New User, and press Enter.
Input your name using the alphanumeric keypad.
✔
Note that you may need to use the arrow to enter a letter if the previous letter was on the same
number key.
✔
Note that you may enter Capital Letters and/or add a space to your name by selecting the appro-
priately labeled function keys.
✔
Note that you may use numbers in your name by selecting the shift key.
•
When your name is complete, choose Enter.
PIN protection.
•
If you have a PIN, you will be asked to enter it here
•
If you are a new user, you may choose to PIN protect your protocol files.
✔
Note that you will not have the opportunity to select PIN protection at any other time.
You will now find yourself at the Home Screen
To run a stored protocol.
•
From the Home screen press F1 to display the protocol library.
•
Use the arrow keys to highlight the desired protocol.
•
Press Enter and from the selection box, choose Run Protocol
•
Confirm the selections in the Run Preparation screen:
✔
Hot start conditions, temperature measurement method
✔
Note that you may choose to link protocols from this screen
•
Press F5 to Run Protocol.
Note that you may jump instantly between the Run Screen and the Home
Screen using the shift key and then selecting F1 for Home Screen or F2 for
Run Screen
Quick Guide
