Bio Medic Data Systems DAS-8010, Руководство пользователя

Страница: 8 / 24

www.BMDS.com 1-800-526-BMDS or 302-628-4100 for Support Questions
SYSTEM SETUP
8
Setup instructions for both the DAS-8010 and DAS-8020 are exactly the same and extremely easy.
1. Unpack and inventory system components. There should be the DAS-8010/8020 reader unit,
a 12-volt power supply, an RSP smart probe, and a black RJ-11 coil cord for connecting the smart
probe to the reader system. A disc with the BMDS Serial USB Driver is provided for installation on
Windows XP through Windows 7 (Windows 10 provides native Serial USB support).
In addition, if ordered, there could be a USB data cable, a 9-pin Serial data cable, a smart probe
stand, and DASHost Utility Software.
2. Connect the unit to the 12-volt power supply. Plug the power supply to a standard outlet and
test for function by turning on the power switch located on the front of the unit. Turn the unit off after
confirmation. The LED is RED for OFF and ORANGE for ON.
NOTE: The power supply provided has a small BMDS sticker located on the bottom of the unit. It
has been calibrated to operate with all BMDS reader systems. DO NOT use non-approved power
supply units with your readers. Doing so could create interference with transponder reads, failure of
the sensitive smart probe or complete de-tuning of all equipment components.
3. Connect the RSP Smart Probe to the reader system. Using the supplied black coil cord, connect
one end to the back of the reader and the other end to the smart probe. This is a specially configured
6 pin RJ-11 cord provided by BMDS and not a standard phone or other similar in appearance cord.
BMDS cords have a reverse connection and special power handling capabilities. Do not substitute
coil cord for generic cord.
4. Connect the final data cable from the unit to a functioning respective port on your computer.
The new DAS-8010 and DAS-8020 systems can now connect to your computer via three different
port options. Two modern USB options (Serial USB or Keyboard HID USB) and a legacy 9-pin
RS-232 serial connection. If connecting by either serial USB or RS-232, a BMDS driver will need
installation for systems running Windows XP through Windows 7. Windows 10 has native driver
support. Please contact BMDS for connections to Windows 8 and Windows 8.1.
5. Power on the system. Once all connections have been made, you can power on the complete
system using the power switch. In addition to the Power LED light, the probe LED and connection
LED will light to indicate that the system is functioning correctly.
6. Start to collect data reading the specific transponders tuned to your specific smart probe
reader.
NOTICE
The RSP-8004 is an IMI probe and can read only the IMI-500 and IMI-1000
transponder.