Bio Medic Data Systems DAS-8010, Руководство пользователя

Страница: 14 / 24

www.BMDS.com 1-800-526-BMDS or 302-628-4100 for Support Questions
CONNECTING TO DAS-HOST 8000
14
DASHost is now available as either DASHost 8000 supporting only the new DAS-8000 series readers or
DASHost 2.18 supporting both older legacy systems and the new DAS-8000 series equipment.
This manual will briefly provide simple user instructions for use with the DASHost 8000 software only. The
reader system must be connected to the computer via the Serial USB port or 9-pin RS-232 serial port.
To start, connect to DASHost 8000 by following these steps to initiate communication with the computer.
The new DASHost 8000 consist of several colorful window tabs with functions that are grouped together
for easier navigation.
1. Connect the reader system to your computer by either Serial USB or RS-232 port and turn reader on.
2. Open the DASHost 8000 program on your desktop.
3. If properly connected, there should be a COM port selection in the drop down menu available in the Port
Setup section. If multiple COM ports are listed, you will need to refer to Device Manager for Windows
in the Windows Control Panel folder to determine which to use. Most likely, the port assignment will
be COM4.
4. Connect by clicking Connect in Port Setup once the proper COM port has been selected.
5. The Interface/Adapter and Probe/Reader should display the correct reader and probe devices
connected. There will be a display of the current system firmware version for diagnostic if needed.
6. A quick confirmation of communication can also be verified by a simple scan using the reader and
smart probe. Data scanned will be displayed in the Receive Data box.
NOTE
If you do not see Interface/Adapter, Probe/Reader, or scanned data in the Receive
Data box, you are not communicating with your computer and will need to re-
attempt connection.