Bio Bronpi ELSA Y PAULA, Инструкции по установке, эксплуатации и обслуживанию

Страница: 53 / 154

52
11 ALARMS
In case of an anomaly during the operation, the electronics of the stove intervenes and highlights the irregularities that have ocurred in the
different working phases, depending on the type of fault.
Each very alarm situation blocks the stove automatically. By pressing the key we unblock the stove. To do this, in the display we must
read the word “Off”. Otherwise, you will not able to unlock it. Once the stove has reached the appropriate cooling temperature, the user can
reignite it.
The following table shows the list of alarm codes as well as a description:
ALARM DESCRIPTION
Er01 Intervention of the safety thermostat, even when the stove is turned off
Er02 Intervention of the safety air pressure switch, only when the stove is turned on.
Er03 Switching off of the stove due to smoke temperature decrease. Possible lack/obstruction of fuel.
Er05 Switching off of the stove due to overheating of the smoke temperature
Er07 Error Encoder: the encoder of the smoke extractor does not receive signal
Er08 Error Encoder: the adjustment of the smoke extractor speed is not possible
Er12 Ignition of the stove unsuccessful
Er15 Power dip - Current interruption.
Er17 The hot air tangential fan does not regulate
Er39 Flow sensor broken
Er41 The primary air flow is not enough during the check-up of the stove
Er42 The primary air flow is high
Values DATE/TIME are not exact after a long power failure
Besides the failure codes, the stove can show the following messages that do not block its operation:
MESSAGE DESCRIPTION
Sond
State of the temperature probes This message appears during the Check Up phase and indicates that the
temperature detected by one or more probes is equal to the minimum value (0ºC) or the maximum value (depends
on the probe) Check that the probes are open (0°C) or in short-circuit (detect the maximum value of temperature).
Hi The room temperature is higher than 50°C.
CLr
This message means that the operating hours have been reached (1200. It is necessary to call the technical
assistance service.
OFF dEL
This message appears when the system has not been turned off manually during the Ignition phase (after the
preload): the system will turn off when it works at full capacity.
PCLr Regular cleaning or burner
EN
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS ELSA AND PAULA