BINZEL-ABICOR 881.3112, Руководство по эксплуатации

Страница: 39 / 108

M-Drive 6 Putting into operation
EN - 13
7 Close and lock the cover (2) .
6.9 Changing the drive rollers
If required, the wire must be cut through and then fed in again.

6.8 Feeding in the wire on page EN-12
1 Open the cover on the M-Drive.
2 Fold the pressure lever (1) outward.
3 Swing the pressure rockers (2) open using the pressure rolls (3) .
4 Unscrew the retaining screws (6) from the wire feed rolls (5) .
5 Replace and re-attach the wire feed rolls (5) .
6 Screw on the retaining screws (6) and use the pressure rolls (3) to close the pressure rockers (2) .
7 Fold the pressure lever (1) back to upper position.
CAUTION
Risk of injury
Physical injury caused by the start of the wire.
• Keep process-side drive away from the body.
1 Pressure lever
2 2 pressure rockers
3 2 pressure rolls
4 2 full-floating axles
5 2 wire feed rolls
6 2 retaining screws
Fig. 9 Changing the drive rollers
1 3
4
5 6
2
NOTICE
• Always replace or reverse the wire feed rolls in pairs.
• Observe the groove geometry and the wire diameter.
• The wire feed rolls should be changed whenever the wire type or the wire diameter are changed or
the wire feed rolls are worn out.