The LEDs for the bintec 4Ge-LE are shown in Figure 6. The table below contains a description of them:
LEDs table
LED
Status
Description
LAN
Tricolor
Green -> connected. Blinking: con-
nection data activity.
Amber -> blinking: auto-test.
Red -> disconnected.
PWR
Monochrome green
Device ON/OFF. This lights up when
connected to the power source.
W
Tricolor
Off -> system stopped.
Red -> interface is unavailable be-
cause it is installing, it is not enabled
(shutdown) or due to auto-test failure.
Yellow -> idle.
• Rapid blinking. It has not registered
in the network or the quality is in-
sufficient.
• Slow blinking. GSM connection
(GPRS).
• Steady. WCDMA (UMTS/HSDPA)
connection.
Green -> connected. Blinking: con-
nection data activity.
3.2 Assembly
3.2.1 Mounting in rack
The bintec 4Ge-LE cannot be mounted in a rack. However, there are other types of mounting.
3.2.2 Standalone
The bintec 4Ge-LE can be placed as a standalone device on a flat, stable surface.
Make sure that there is enough space around the router for ventilation purposes and that the electricity cables can
reach it.
3.2.3 Wall mounting
The bintec 4Ge-LE can be mounted on the wall.
There are two slots on the underside of the device, which are used to fix it to the wall. You can see this in
Underside
Panel
on page 6.
We recommend the following accessories for wall mounting, valid for solid wall and Gypsum board (plaster) wall:
• 2 screws: [Coach Screw Head 90 Degrees. 3.5x30].
3 Components and Power Supply
bintec elmeg
8
bintec 4Ge-LE
