TO CHANGE FROM COMBINED FAN AND ATOMIZING AIR
TO SEPARATE FAN AND ATOMIZING AIR
1. Unscrew ratchet housing assembly (28) and
remove material needle and attached parts (22,
23, 24, 25) (See assembly drawing, page 6).
Use of excessive pressure will cause the piston to exit
the gun body at high velocity, possibly resulting in
personal injury or damage to gun. When removing the
piston, point gun in a safe direction and do not use
excessive pressure.
!
WARNING
2. Remove piston assembly (18) by injecting low
pressure air cylinder air port (A).
3. With 5/32" hex key, remove plug (16) from hole
(B) on inside of cylinder.
4. Insert set screw (20-2141) into position as
shown in side cut-away. (Set screw is packaged
loose.)
5. Re-install plug (16).
6. Re-install piston (18), 2 springs (26, 27),
material needle (22), and ratchet housing
assembly (28).
(See assembly drawing, page 6).
7. Remove plug (47) from the fan air port (C).
8. Install fitting (36) into port (C). (Fitting is
packaged loose.)
Plug (47)
(remove)
Set Screw (20-2141)
Set Screw (16)
View A
Side Cut-Away
Vie w A
A
C
B
B
EN
77-2672-R7.0 (8/2017)
5 / 16
www.carlisleft.com