BINDTEC YL-300PM, Руководство пользователя

Страница: 8 / 12

- 7 -
5 Binding
1. Turn the power on.
2. Check if the
Start Button and Feed Button’s LEDs
are on.
3. To bind without using the press,
press the
Press Button and wait for the LED to turn off.
4. Place the objects on the item sensor,
and press the Start Button .
5. Once the binding is complete, unload the objects.
6. Check the band’s adhesion and adjust the
temperature if necessary with the temperature control knob.
Be careful not to touch the press or band during operation.
6 Removing a Failed Band
How to fix a band that is jammed or has deviated from the rail
1. Open the front cover and the band reel cover.
2. Using scissors, vertically cut the band that has clustered on each side of the
main roller.
3. Press the
Feed Button for about 1.2 sec to widen the gap between the main
and idle rollers.
Remove the shredded band by pulling it, as horizontally as possible, in the
reverse direction of the main roller.
4. Remove any band pieces from the rails.
5. Supply the band by following step no.
5
of 4. Band Installation .
In case of a jam or the rail departure of the band, quickly pressing the
Feed Button will cause the band to be wrapped around the main roller, making it
difficult to remove the band. Thus, it is important to carefully follow the steps above.
①
Power
switch
Spa
cer
Tape unrill
direction
Caution
Caution
Power Switch
Feed/Reset
Start
Press/Reverse