BINDTEC YL-300PM, Руководство пользователя

Страница: 6 / 12

- 5 -
1. Power Switch
It turns the power ON or OFF.
2. Start Button
The Start Button’s LED blinks when the band is supplied to the rail, and the
object is placed in the correct position. At this point, press the button to start the
binding.
3. Feed/Reset Button
The Feed Button’s LED blinks if the band is not supplied to the rail. To supply
the band, press the Feed Button to rotate the main roller forward.
Reset : Press and hold the Feed Button for about 1.2 sec to loosen the gap
between the main and idle rollers, and adjust the band input. Furthermore,
perform this function to remove the band in case it is jammed. Then, press the
button again to return to its initial state.
4. Press/Reverse Button
When the power is on, the LED on the Press Button turns on and the unit is set
to press binding mode.
Press the
Press Button to turn the press on or off.
Reverse : Press the Press Button for about 1.2 sec to let the main roller turn in
reverse, allowing the attached band to be removed.
5. Item Sensor
The Item Sensor’s LED blinks when the item to be bound is in place.
6. Temperature Control Knob
This knob is used to adjust the heater’s temperature, whereas
turning the knob clockwise increases the temperature.