Binatone RL-590, Инструкция по эксплуатации

Страница: 7 / 32

7
ENGLISH
Using the appliance as the lantern with
automatic switch-on
X
Connect the lantern to the electric network by inserting the
plug into a power socket.
X
Set the operation mode switch (5) to «ON» .
X
After electric power supply is cut off, the appliance will start
operating in the autonomous emergency mode. If light does
not go on, please pull the rope switch.
Warning: when you stop using the lantern, set the
operation mode switch to «OFF» in order to save
battery charge.
The emulation mode of emergency mode
(only for RL-595)
You can check the functioning of emergency lighting network
by pressing the «Test» button (14) , emulating power supply cut-
off.
Replacing the external safety fuse (only for
RL-595)
X
The emergency lantern RL-595 features the built-in external
safety fuse
(17), installed on the body of the appliance (6).
This safety fuse protects power circuit of the rechargeable
battery.
X
To replace the safety fuse, unscrew the protection cover with
a cross screwdriver, take the fuse out of the receptacle and
replace it with a new one.
Warning: use only the safety fuses with the rating value of
3A 250 V to replace the burnt-out safety fuse.
Replacing the fluorescent lamp
X
Unscrew the cover fixing screws (2) with a cross screwdriver.
X
Take the cover (3) off and rotate the lamp (1) in any direction
until the projections on the lamp align with the gutters of the
receptacle. Take the lamp out.
X
Replace the lamp with a new one: insert the new lamp as far as
it goes and make a quarter turn in any direction.
Warning: do not touch the cap of the lamp.
X
Close the cover.
X
Screw the cover fixing screws.
Installation and transportation
X
You can install the lantern on a horizontal or vertical surface
using the mounting holes
(10) on the body of the appliance.
X
You can carry the lantern from one place to another using the
protrudable handle
(8) . To do so, take the handle out by
pulling it in the direction opposite the body of the appliance.