To set
additional
‘local’ dialling
codes
1
Press the
PROG
button then
2 4 1
2
Key in the first dialling code (up to 6 digits)
3
Press the
PHONE/OK
button to confirm
4
Press
4 2
5
Key in the second dialling code (up to 6 digits)
6
Press the
PHONE/OK
button to confirm
To turn
Indirect
Network on
and off
You need to do this
on each handset
.
1
Press the
PROG
button then
1 4
2
Use the
or
buttons to set:
0
for Indirect Network
off
1
for Indirect Network
on
3
Press the
PHONE/OK
button to confirm
When you make a call, the handset will dial the network
access code when you dial a number beginning with 0,
except when it’s to one of the ‘local’ codes you have set.
When a call is routed via Indirect Network,
LC
is shown
on the display.
!
Note — for Indirect Network to work, you must dial
the phone number (or select it from memory, LNR
memory or Caller Display memory)
before
you press
the
PHONE/OK
button for an outside line.
Indirect Network
34
Troubleshooting
!
The Lifestyle 100 must be serviced by trained
engineers. NEVER attempt any repairs or
adjustments yourself — you could make the problem
worse and invalidate the Guarantee.
ALWAYS check
first that:
■
you have followed all the steps listed on pages 5 and
6 to install and set up your Lifestyle 100
■
all
connectors
are firmly inserted in their sockets
■
mains power
is switched on at the socket
■
the handset’s
batteries
are correctly and securely
installed, and are not run down
Everyday use
“I cannot make
or answer calls.”
If the handset’s display is blank, it may be
switched off
.
Press the
HANG UP/C
button to switch it back on.
Check that the base unit’s
mains power adapter
is
plugged in and
power is switched on
. The base unit
needs mains power for normal operation of the phone
— not just for charging the batteries.
Make sure you’re using the
telephone line cable
that
was supplied with your Lifestyle 100. Other telephone
line cables might not work.
Move the handset
closer
to the base unit.
Check the
Battery Level
symbol on the display. If it is
low, replace the handset on the base unit or charger
pod to recharge the batteries.
Switch off power
at the mains socket, wait for a few
seconds and then
switch back on
. This may solve the
problem.
Binatone Help Line:
0845 345 9677
(Local Call rate)
35
E:\Binatone2004\Lifestyle\Lifestyle_100\Lifestyle-100_UK_01.vp
14 April 2004 15:14:09
Color profile: Generic CMYK printer profile
Composite Default screen
