d. Place the Terrain 650 units in the charge cradle in an upright position
and facing outward. The charge LED indicators will light up.
e. It takes about 10 hours to fully recharge the batteries if they are
completely run down. New batteries takes up to 14 hours to fully
charge.
f. Charging the battery pack (using adaptor)
Lift up the charge socket cover located on
the right side of the handset.
Insert the round connector of
the 9.0V DC/200mA adaptor
into the charge jack.
Plug the mains adaptor into a
240V AC, 50Hz main socket
with the switch on the socket
set to OFF. Use only power
supplies listed in the user
instruction. Csec AC Adaptor
brand ; Model -CSD0900200G
power supply
Then switch ON the main socket.
Battery meter
The battery meter is located in the left corner of the LCD Screen. It
appears like a battery with three bars inside. These indicate the
amount of power available. When the battery level reaches it
minimum level in PMR on mode, unit will emit two beep tones and
automatically the unit will power off.
The Terrain 650 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the Terrain 650 will emit
a “beep” sound for every 10 seconds in normal mode.
Battery charge at very low level. When the battery level
reach it minimum level while unit is on mode, unit will emit
two beep tone and automatically turn off the unit.
Important: Charge the unit for 10-14 hours.
CAUTION : Risk of explosion if battery is replaced by an incorrect type.
Disposed of used batteries according to the instructions.
Battery life
The Terrain 650 has a built in power saver to make the batteries last
longer. But when you are not using the units, turn them OFF to
conserve battery power.
Mic/spk jack
Important:
Always turn off the PMR units
when charging. This will
shorten the charging time.
Main socket
Charge jack
