Binatone Telecom plc
operates a policy of continuous product
improvement, and so reserves the right to make changes to the product
and functions without prior notice.
Declaration of Conformity
And conforms to the following relevant standards:
The
complies with the essential requirements
Binatone Terrain
50
Waste electrical products must not be
disposed of with household waste.
This equipment should be taken to
your local recycling centre for safe
treatment.
10.Troubleshooting Guide
ETSI EN 300 296-2 V1.1.1
ETSI EN 301 489-5 V1.3.1
ETSIEN301489-1V1.6.1
EN60065-1:2001
Symptom
Solution
No power.
The
may be weak.
battery
Check if the batteries are installed properly.
Reception
is weak.
Press the
button to increase the receiver volume level.
UP
The receiving signal may be weak and/or out of range.
Cannot change
CTCSS sub-
channels.
Range is limited.
Wearing the radio close to the body, such as in a pocket or on a
belt, will decrease range; change the location of the radio.
limit the range significantly.
Open fields provide the maximum range, while steel/concrete
structures, heavy foliage, and use in buildings and in vehicles may
The maximum range will vary depending on terrain and environment.
Replace with new
if the charge level indicator gets low.
batteries
Batteries may be weak.
Sound distortion
problems.
Radios too far apart. Obstacles interfere with transmission. Talk
range is up to
Kms. in a clear unobstructed conditions.
Radios too close. Radios must be at least 2 meters apart; increase
your distance.
If you are transmitting, speak in a normal tone of voice, 5 cm
away from the
(microphone.).
MIC
If you are receiving, lower the volume to a comfortable level.
Key lock mode must be deactivated if the Key lock icon (
) is
displayed on the LCD Screen.
Press the
or
button to change the CTCSS sub-channel.
UP
DOWN
To change CTCSS sub-channels, press the
button twice, the
CTCSS sub-channel number flashes on the LCD Screen.
MENU
Batteries may be weak.
Replace the old batteries with new one.
No
communication
Check the Channel and the CTCSS code setting. Both the
Transmitting and Receiving PMR units should have tuned to the
same Channel and CTCSS code (if applicable).
See the “Effective Range” diagram.
If this happens, press the
and
buttons at the same
time to activate the Monitor function.
MENU
DOWN
This equipment is intended for use in:
Austria
Finland
Denmark
Ireland
Portugal
Estonia
Italy
Slovenia
Belgium
France
Liechtenstein
Sweden
Bulgaria
Germany
Luxemburg
Switzerland
Croatia
Greece
The Netherlands
Turkey
Cyprus
Hungary
Norway
UK
Czech
Iceland
Poland
Romania
Countries of use
Latvia
Spain
Slovakia
UK (
BTP
) Ver
2 Mar
.0
9
6
10
