9
6.2.1. Point-to-Point IR Control - Stereo (3.5mm) IR Receiver
When using a powered IR receiver, the DIP switch for IR RCVR PWR should be set
to ON. In this case a 3.5mm (1/8
"
) stereo jack has to be used to send 9V DC power
to the receiver.
CAUTION: Do not
connect a mono cable to this connection as damage may
occur.
1
ON
FIGURE 6: Point-to-Point IR settings
6.2.2. Control System - Mono (3.5mm) IR Receiver
When using a control system which generates the signal through a mono jack, the IR
RCVR PWR switch should be in the OFF position.
1
ON
FIGURE 7: Control System IR settings
6.3. Firmware Update Operation
Detailed instructions and updated firmware will be posted to the product support
page as they are released.
6.4. Thread-Locking Power Supply
This receiver is powered by the included power supply.
CAUTION: Do not
connect the power supply to the device until it is
completely installed and all connections have been made.
CAUTION: Do not
connect a third party power supply to the device unless the
voltage and amperage matches the power supply provided with the receiver.
7.
DIP Switches
IR Signal (Tip)
GND (Ring)
9V DC(Sleeve)
Pinout Configuration
DIP Switches
IR Signal (Tip)
GND (Sleeve)
Pinout Configuration
