+420 608 411 090
REPLACEMENT MANUAL
@bimmerjakes
www.BimmerJakes.com
8 Installation of the new cover
It is necessary to test if the new cover fits in the groove as
the original one before pasting it. Otherwise try to clean the
groove again until the cover fits well. It is possible, that the
area of new cover contains redundant bulges. In case of that,
grind the redundant materials of.
9 Pasting the new cover
We attach the cover slowly and keep controlling the right di-
rection of attaching. We have to make sure, that the cover will
fit properly before it touches the sealant.
Subsequently the new cover of sealant is applied in the groove.
Ideal type is the sealant for pasting car glasses. The sealant
must be applied evenly and the groove must be at least ¾ full.
Insufficient amount of sealant could cause insufficient ability
to seal and decrease ability to be water resistant.
You must press the cover fully to the groove and make sure,
that the cover is surrounded by sealant sufficiently.
10 Fixation
The final step of the process is to fix the headlight to avoid
undesirable movement of the cover during solidification.
The best way how to fix the headlight is by using clamps
and tapes. Protect the cover by using foil to avoid dirt from
sealant during manipulation. It is necessary protect the cover
from any movement during solidification.
11 Conclusion
The time of whole process depends on the technicians expe-
rience and the type of headlight. By respecting all recommen-
dation is the chance of good result very high.
12 Sent it to us
We will be more than happy if you share your before/after
photos with us, we will post them at our social media pages
where we can tag you if you want. You can even write a review
for specific product at our eshop.
Follow us
