4
26. Apply a coating of lubricant to the inside surface of the tube. Best performance will be achieved when the
lubricant is applied evenly over the whole surface.
27. Insert the tube through the center hole in the carriage.
28. Apply a coating of high grade bearing grease to the piston and insert it into the tube. Use your fingernail to
deflect the lip of the seal to insert it in the tube. Again note that the orientation of the piston to the carriage
must be maintained as described previously.
29. Place the assembly back in the arbor press and with the shaft used before, re–couple the piston with the
carriage.
30. Lightly lubricate the four guide rod bearings in the carriage by hand or with a swab. Insert the two guide
rods through the bearings in the carriage.
31. Attach one end block to the guide rods. Insert the tube into the large hole in the end block. Press firmly on
the tube to seat it in the O–ring. Tighten the cap screws finger tight only.
32. Install the second end block onto the guide rods and tube body. Fasten with the two cap screws, finger tight.
33. Slide the carriage to one end of its stroke and tighten the cap screws at that end to the torque
specifications listed in the chart.
34. Repeat process for opposite end.
BORE SIZE
TORQUE FT–LB (N–M)
BORE SIZE
TORQUE FT–LB (N–M)
007 (8mm)
1.6 (2.17)
09 (27mm)
20.1 (27.25)
01 (12mm)
2.1 (2.85)
12 (32mm)
50.8 (68.9)
02 (14mm)
5.8 (7.86)
17 (38mm)
50.8 (68.9)
04 (18mm)
5.8 (7.86)
31 (50mm)
179 (242.7)
06 (22mm)
12.5 (17)
Form: BMS-1036
Rev. A
Product Instructions
Ultran
®
Slide Rodless Cylinder
Repair Instructions
Bimba
25150 S. Governors Hwy
University Park, IL 60484
Tel: +1 800 44 BIMBA
Fax: +1 708 235 2014
Email: [email protected]
Website: www.bimba
