25/40
Attention: The fan must be installed so
that the blades are more than 2.3 m
above the flooring level, as shown.
Attach the Mounting Bracket to the ceiling following these instructions. Before drilling into
the ceiling, make sure that you do will damage any internal ductwork and that the anchoring
devices do not compromise the strength of the ceiling.
To mount and fasten the appliance, proceed as follows and refer to the figures:
Wooden ceiling
Make sure the surface has been fireproofed,
and that the Mounting Bracket is secured to
beams, or joists.
Turn off the service power line using the circuit
breaker.
3)
Using the Mounting Bracket (1) as a guide,
mark the points where the holes for the 4
self-tapping screws will be drilled.
4)
Remove the Mounting Bracket (1), drill the
4 holes (diam, 3mm), and install the bracket
to the ceiling with the 4 self-tapping screws.
The screws must be tightened fully and the
plate securely fastened to prevent the fan
from oscillating.
Concrete ceiling
Turn off the service power line using its circuit
breaker.
3)
Using the mounting bracket (1) as a guide,
mark the diametrically opposite points
where the holes for the 2 expansion plugs
will be drilled.
4)
Remove the mounting bracket (1), drill the 2
holes (diam.8) and insert the 2 expansion
plugs: use the nuts and insert the flat and
elastic washers for fixing. The nuts must be
tightened fully and the plate securely
fastened to prevent the fan from oscillating.
