16
4.
Insert the power cord into the lower and middle columns so that the power plug is at
the bottom.
5.
The junction between the two cables of electric cord is made through the male and
female connector plugs: this connection must be ensured by means of the special
plastic shell supplied.
Please, operate as follows:
Open the plastic shell: press the central tab, so
that the cover disengages and opens like a book.
Make sure that the two plugs are completely
connected, and insert them into the plastic shell
as shown in the figure.
Close the cover so that the two clips are inserted
in the corresponding slot. Make sure the cover is
locked.
6.
Position the upper column (complete with heating unit) on the middle column (check
that the power cable is perfectly seated inside the column); to lock it rotate
anticlockwise until it is fully seated and tighten correctly.
7.
Turn the appliance over to the ground on a cloth or other soft surface (taking care not
to damage or deform the heating unit, columns and base, so as not to compromise its
proper functioning.); place the cord inside its slide on the bottom of the base and
secure it by means of the fixing plate and the two screws supplied in its seat.
8.
Reposition the appliance in an upright position.
Thereafter, check that the support columns are steadily coupled.
