-10-
6. Scope of delivery
1 pre-assembled chassis with pump unit
1 pre-assembled tiller arm
1 axle
2 roll pins
Please check the completeness of the delivery and ensure that all parts are free
from any transport-related damage or any damage in general. Please contact the
seller from whom you purchased the product should there be any parts missing
or damaged.
7. Before use
7.1 Unpacking
1. Unpack all parts and lay them on a flat, stable surface.
2. Remove all packing materials and shipping devices if applicable.
3. Make sure the delivery contents are complete and free of any damage. If you
find that parts are missing or show damage do not use the product but contact
your dealer. Using an incomplete or damaged product represents a hazard to
people and property.
4. Ensure that you have all the accessories and tools needed for assembly and
operation. This also includes suitable personal protective equipment.
WARNING!
The product and the packaging are not children’s toys! Children
must not play with plastic bags, sheets and small parts! There
is a danger of choking and suffocation!
7.2 Assembly
1. Insert the tiller arm (3) with the roller (h) facing the small piston rod (g) into
the hinge (d). Use a hammer to insert the axle (b) through the hinge (d) and
the tiller arm (3). Make sure the holes for the roll pins (c) are aligned with the
respective slots on the hinge (d).
2. Set the control lever (4) to the “lower” position. Pass the chain (j) and the
adjusting bolt (i) through the centre hole of the axle (b).
3. Use a hammer to insert the two roll pins (c) into the two outer holes of the axle
(b) aligned to the slots in the hinge (d).
4. Press the tiller arm (3) all the way down and hold it in position with one hand,
while removing the safety pin (a) from the hinge (d). Move the tiller arm (3)
back to the upright position.
(IM)237‐000413_RHP25_GB-IM_V4_150626.indd 10
7/3/15 17:09
