Billy Goat BC2600HHEU, Руководство пользователя

Страница: 12 / 24

Part No 501606 12 F041513B
BC2600 Euro
Hydro Series Brush Cutter Owner’s Manual
B
LADE
D
RIVE
B
ELT
T
ENSION
READ all safety instructions before servicing unit.
DISCONNECT spark plug wire before servicing unit.
The Blade Drive belt is under constant tension by the idler arm on the deck
1. Disconnect spark plug wire.
2. Loosen four screws (27) holding belt deck cover (29) and remove the cover.
3. Examine condition of belt and amount of tension on belt.
4. If the idler is not providing enough tension inspect the spring (item 50) attaching it to the spindle base. If not enough
tension is being put on the arm, replace the spring.
7. Replace engine base door (29) and secure with screws removed earlier.
8. Reconnect spark plug wire.
9. Check belt tension by operating unit under conditions that caused belt slippage. If belt continues to slip it may require
replacement before operation may continue.
B
LADE
C
LUTCH
A
DJUSTMENT
READ all safety instructions before servicing unit.
DISCONNECT spark plug wire before servicing unit.
1. Disconnect spark plug wire.
2. As the clutch/brake wears or begins slipping or squealing, adjustment may be required to maintain proper cable tension
and clutch engagement. A properly adjusted blade clutch should require 10 lbs. of force to depress the end of the clutch
lever. The blade clutch cable spring should stretch 1/4” to 3/8” (6.4-9.5 mm).
3. Adjust cable tension by tightening or loosening cable adjustment nut on rear of engine base (see below). Be sure to
leave enough slack in cable to allow blade brake to engage.
Blade Cable Adjustment
If clutch continues to slip or squeal, do not operate equipment until adequate adjustment or repair
has been performed. Improper adjustment can cause clutch to overheat and slip, greatly reducing
performance and clutch life.
4. Reconnect spark plug wire.