Billion ADSL Modem / Router BIPAC-711C2, Руководство пользователя

Страница: 9 / 53

Chapter 2 Using the ADSL Modem/Router
5
2.3 The Rear Ports
LINE
(RJ-11
connector)
Connect the supplied RJ-11
cable to this port when
connecting to the ADSL
USB
(711 C2 only)
Connect the supplied USB
cable to this port when
connecting to the PC.
Reset
Press it to restore the factory
default setting back
LAN
(RJ-45
connector)
Connect the supplied LAN
cable to this port when
connecting to a NIC (Network
Interface card) in PC or to a
LAN such as an office or
home network.
Power
(jack)
Connect the supplied power
adapter to this jack.
2.4 Cabling
Through USB Port (711 C2)
The product can be used as a Network Adapter on your PC. That means you do not have to install a
network adapter first on your PC before connecting the ADSL Modem/Router. Just connect the supplied
USB cable to the USB port of the ADSL Modem/Router and connect the other end to the PC.
Make sure that your ADSL Modem/Router and PC are turned on. On the front of the product is a bank of
LEDs. As a first check, please verify that the PWR, USB and ADSL SYN LEDs are lit.
As long as the cables are connected and the LEDs are lit normally, follow section
“3.1.1 Installing the
USB Driver”
below to setup this device.
Through Ethernet Port
The product’s LAN port supports MDI/MDIX auto-detection, so that it can be connected to the PC or
HUB/Switch directly. Make sure that your ADSL Modem/Router and PC are turned on. On the front of the
product is a bank of LEDs. As a first check, please verify that the PWR, LNK and ADSL SYN LEDs are lit.
As long as the cables are connected and the LEDs are lit normally, follow chapter 3
“Configuration”
below to modify the network settings.