3.4 Opening and closing the weight repeater to set the
switch
✔
Disconnect the mains cable and serial cable from the repeater;
✔
unscrew the four screws that fix the upper cover of the display using a
screwdriver;
✔
remove the cover;
✔
power by keeping the SETUP switch depressed: the position of the
decimal point will appear on the display. Press the switch to move the
decimal point to the four available positions (0 by default; 1, 2, 3
decimal numbers) in the cyclic mode.
✔
Release the switch for 4 seconds to allow the terminal to return to the
display mode. Remember that the settings are only valid for the CB
string (see par. 5.3.1 on page 1-23). In the case of the EXTENDED
string (see par. 5.3.2 on page 1-24), the settings make no difference
and the decimal point is set automatically.
✔
Close up the instrument by working through the operations described
above in reverse order.
RD52HL
1-18
