Page 2 of 8
Congratulations on your Titan Amplifier purchase! Your amp is made in America
to the extent possible, using components from American companies whenever
available. It is a state-of-the-art audio power amplifier built from the ground
up specifically for motorcycles. Should you have questions regarding product or
installation, feel free to dial the number found at the end of this guide.
CAUTION!
The Titan Amplifier is very powerful and care must be taken to protect hearing
as well as conform to any noise ordinance your area may be subject to. Using
Titan at extreme volume levels may cause hearing damage! Please exercise
good judgment.
1. Disconnect battery - negative cable first.
DO THIS NOW!
2. Remove outer fairing (consult shop manual)
3. Place Titan amplifier components
4. Make Titan connections (pages 4-7).
5. Test Titan and reinstall fairing.
6. Enjoy the latest sound technology on your bike.
Tools Required.
◊
Torx head screwdrivers #25 & #27
◊
Socket set
◊
Phillips screwdriver
Additional parts recommended:
2 ea Biketronics Titan II 6-1/2” high performance
replacement speakers.
Note: Be sure to use speakers with at least 100W
RMS power handling capability and 2-ohm or
greater imedence.
INTRODUCTION
INSTAllATION OUTlINe
Peel adhesive backing from amps and place on each side of fairing as shown in Figure One
ElectraGlide
: Place power supply atop
radio. Place amps on either side of fairing.
Refer to instructions included in wing tip
packet.
RoadGlide
: Power Supply mounts to
inner fairing bulkhead. Place amps where
convenient.
TITAN AmplIfIeR plACemeNT (SUggeSTeD)
Figure 1 – Amp and Power Supply Placement
