12. Place a wheel spacer over each end of the axle and insert a pin through the hole to secure it in place
as shown in Fig.18. The loop of each pin should snap over the axle when fully installed as shown in
Fig.19.
13. Fasten a washer to each end of the short
crossmembers using a 3/4” bolt (Fig.20).
This will prevent the shock cords from
slipping off the end when they are used
as tie-down points.
15. You can now hang your shock cords
around the crossmembers for easy access
as shown in Fig.22.
The trailer assembly is complete. See the:
Hitch Mounting Instructions,
Attaching the Trailer to the Hitch Instructions, and
Tips for Using Your Trailer Safely
and you'll soon be ready to use your new trailer.
For minimal rolling resistance, check tire pressure before each
use.
Fig.20
Fig.18
Fig.19
14. Mount the self-adhesive reflectors on the
rear trailer crossmember as shown in
Fig.21.
Fig.22
Fig.21
reflectors
insert
straight
end of pin
from top
spacer
pin partly
inserted
pin fully
inserted
