2
Carbon fiber stab bolt tube(12x480mm)
8
Horn
4
pivot & round hinge(5x68mm)
1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Elevator
Keep some space about 1mm width between
elevator and tailing edge.
Apply instand type AB glue to the holes in the stabilizer
and hinges.
4
Clevis
4
4
Screw (2x12mm)
2
Lock Nut (2mm )
Push rod(70x2mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Epoxy the elevator to the stabilizer.
Install the control horn and connect the linkage.
The steps to assemble the servo for elevator.
Ball joint
Ball joint
Lock Nut (2mm )
Lock Nut (2mm )
4
Clevis
4
4
Screw (2x12mm)
2
Screw (2x12mm)
Screw (2x12mm)
Lock Nut (2mm )
Push rod(2mm)
Push rod(70x2mm)
Screw (2.6x12mm)
4
4
Washer(3x8mm)
Make sure hinges are
mounted in the same line.
8
pivot & round hinge(5x68mm)
17
18
20
21
4
19
Accessory list for the coming installation steps.
2
Screw (3x15mm)
2
Washer(3x6mm)
Screw (3x15mm)
Washer(3x6mm)
1
Drop tank
Mount the fuel tank, battery and receiver to
the fuselage.
Put the drop tank to the belly of fuselage.
Step for assembling the fuel tank.
Step for assembling the cockpit and canopy.
Fix the drop tank by screws from the inner fuselage as
illustration.
Steps for assembling the drop tank.Factory already
set blind nuts in the drop tank.
45
44
46
47
9
49
Accessory list for the coming installation steps.
48
