BigJoe PDM-20-154, Руководство пользователя

Страница: 2 / 28

1
Miller® is a registered trademark of Miller Equipment, Franklin PA.
2
DBI/SALA® is a registered trademark of DBI/SALA, Red Wing, MN.
2 Document 367
2. SAFETY PRECAUTIONS
The following safety precautions must be adhered to
at all times.
• All warnings and instructions must be read and
understood before using the equipment.
• Equipment must not be altered in any way.
• Equipment must be inspected by a qualified person
on a regular basis.
• Be certain that required restraining means such as
safety belts, lifelines, and chains are properly used.
• Safety belt buckles must be visually inspected to
assure proper and secure connection before use.
• The self retracting lifeline should be attached to the
back Dee ring only on the safety belt.
• Replace any safety belt or life line that sustains per-
manent deformation or is otherwise damaged.
• Be certain that the lifting mechanism is operating
smoothly throughout its entire lift height, both empty
and loaded.
• Be sure that mast is vertical--do not operate on a
side slope.
• Be sure the platform is not tilted forward or rearward
when elevated.
• Be sure the truck has a firm and level footing.
• Before personnel are elevated, mark area with
cones or other devices to warn of work by elevated
personnel.
• Avoid overhead wires and obstructions.
• Personnel are to remain on the platform floor. Use of
railings, planks, ladders, etc., on the platform for pur-
pose of achieving additional reach or height is pro-
hibited.
• Personnel and equipment on the platform must not
exceed the available space.
• Lower platform to floor level for personnel to enter
and exit. Do not climb on any part of the truck in
attempting to enter and exit.
3. CONTROLS AND INDICATORS
Steering Control Head of the truck is covered in
Supplement 220
.
A remote lift, lower and stop switch is located on the
platform as shown in
Figure 1. An emergency power
disconnect (EPD), keyswitch and an emergency low-
ering valve are located on the rear of the truck as
shown in
Figure 1.
4. OPERATING PROCEDURES
WARNING: Understand truck limitations and oper-
ate the truck in a safe manner so as not
to cause injury to personnel. Safeguard
pedestrians at all times. Be sure you
have read and understand the Safety
Precautions listed in paragraph
2.
Users shall comply with all requirements indicated in
applicable OSHA Standards and current edition of
A.N.S.I. B56.1 Part II. By following these requirements
and the requirements in this supplement you will get
many years of safe, dependable service from your Big
Joe lift truck.
The basic operation of the truck is covered in the PDM
Manual No. 901356. Steering Control Head operation
of the truck is covered in Supplement 220. Refer to the
Miller®
1
Equipment manual supplied with this truck for
information on the proper use, safety precautions and
maintenance procedures applicable to the Safety Belt.
Refer to the DBI/SALA®
2
Operation and Maintenance
manual supplied with this truck for information on the
proper use, safety precautions and maintenance pro-
cedures applicable to the Self Retracting Lifeline. Prior
to operating the truck a check of safety items should
be performed to insure the operating integrity of these
items.