Assembly – BiG800 Workstation With Half Width Drawer
Note: Illustrations not to scale
Place handle
L
onto front beam of drawer
I
. Tap with rubber mallet to secure.
Separate drawer runner set
M
into
drawer runner and drawer slider using
black release clip
Slot drawer front & back beams
I
into
the drawer sides
J
to make frame.
Knock into place with a rubber mallet
1
2
3
10
11
12
Insert short side beam
B
into the two
top keyholes of the right front upright
RF
.
To create middle frame, slot side beam
with centre studs
A
into lowest keyholes
of middle front
MF
and middle back
MB
upright. Please ensure that the side beam
A
is facing towards the outside
Slot a drawer support beam
K
into
uprights leaving two keyholes clear at the
top. Knock into place with a rubber mallet
Attach drawer runner to side of drawer
J
using screw driver and 7mm spanner.
Ensure that the screws are placed into
the outer holes on the drawer frame and
the outer holes on the drawer runner.
Please also ensure that the black drawer
release clip is facing towards the front of
the drawer frame when securing.
4
5
To make right hand side frame, slot
short side-beam
B
into right back
RB
and right front
RF
uprights. Use lowest-
level keyhole. Knock beam into place
with rubber mallet.
Slot drawer support beam
K
into the
uprights. Leave two keyholes clear at top.
Knock beam into place with a rubber mallet.
8
9
J
B
L
I
J
M
K
A
A
K
Repeat steps 4 and 5 to secure second
runner onto other side of drawer frame.
6
I
Push plastic feet
S
onto the base of all
uprights.
7
RB
S
RF
B
MB
MF
RF
Tip: Assemble drawer
frame on a firm flat
surface
