- EN 4 -
Overview of the components
1
2
3 4 6 7 8
5
10
11
12
13
14
17 18
16
15
9
1. HANDLE
2. SPEAKER
3. SKIP- button
4. SKIP+ button
5. DISPLAY
6. PRE. / ALARM button
7. INFO / DIMMER button
8. SLEEP / SNOOZE button
9.
MENU button
10.
ENTER / CLOCK button
11. AMS / MODE button
12. VOLUME CONTROL KNOB
13. STANDBY / FUNCTION button
14. AC SOCKET
15. TELESCOPIC ANTENNA
16. BATTERY DOOR
17. HEADPHONES JACK
18. AUX-IN JACK
Start-up of the device/introduction
•
Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is easy to
operate the machine.
•
Ensure that the device is sufficiently ventilated.
•
Remove the protective film from the display if it is still present.
Power Supply
•
Ensure that the voltage is the same as that indicated on the model identification plate.
• Connect the power cable supplied (see battery compartment if necessary) to a properly installed
safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment.
2. Insert 4 batteries of type UM-2 (“C” size) 1.5 V. Please ensure that the polarity is correct (see the
floor of the battery compartment)!
3. Then close the battery lid.
NOTE: When a mains cable is connected the batteries are automatically switched off.
Turning device on/ off
• Press the “STANDBY / FUNCTION” button to turn the device on.
• To turn off the product, press and hold the “STANDBY / FUNCTION” button for approx. 3 seconds.