3. LED Status
Turn the switch 1 and 2 to the “ON” position to initialize when you use the 6G-B first . LED flashes rapidly for
10 seconds after power on. When the LED is steady on, Initialization is ok , Then cut off the power and turn the
switch S1 and S2 into corresponding flying type. Power on again and the LED is steady on .
4.
Installation method.
4.1 .The 6G-B must be installed in a flat and stable platform close to the center of gravity of your plane. The
connecting method refers to the following diagram:
4.2 The 6G-B must be installed to towards forward in a level platform as showing :
(Attention: Don’t reverse installation
.)
5.
Mode switch
The SW control signal is assigned to the appropriate channel. “SW” is the switch of changing flight mode. When use
the 2-section switch, it can change from Gyro Off Mode into Balance Mode. please check the following table:
Flight Mode
Range of switch
Signal Pulse Width
LED Status
Gyro Off
Less
1500US
Steady on
Balance
More
1500US
Steady on
6. Adjusting method
6.1 The screw of ALE, ELE contains two functions: Gyro gain Direction, Gyro gain range.
6.1.1 Feedback Direction: the upper part is NOMR ,and the lower part is REV
6.1.2 Gyro compensation range : The Gain Margin is minimum in the centre of the
screw . .clockwish to increase and anti-clockwise to reduce in the NOMR part , anti-clockwise to increase
and clockwise to reduce in the REV part.
Содержание 6G-B
Страница 1: ......
