10
Place the Leapfrog Body squarely onto your collection drum.
Ensure that the rubber seal on the base of the Leapfrog Body makes good contact with the rim of the
collection drum all the way round.
Fit one Primary Filter inside the top of the Leapfrog Body. Fold the top of the Primary Filter over the
top of the Leapfrog Body lip.
Fit the second Primary Filter inside the first. Fold the top of the second Primary Filter over the top of
the Leapfrog Body lip (see the “Filters” section for more information on fitting the Primary Filters).
Caution
Ensure that the filter is fitted with the shaking-handle (sewn onto the
filter) and the writing uppermost. Failure to do so will result in poor
filtration and motor damage.
Always operate the BIG MIKE Leapfrog Wet & Dry in dry mode with both
Primary Filters in place.
Fit the Lid inside the Primary Filters. Position the Lid so that the flat bar on its inner frame is next to
the drum entry spigot at the front of the drum. Make sure it doesn’t foul the inlet entry spigot behind
the Primary Filters.
Place the Leapfrog Body onto your collection drum
