Big Joe PDBB-20-T12, Эксплуатация, техническое обслуживание, список запасных частей

Страница: 15 / 114

901357 2-5
Figure 2-3 Steering Arm Braking Position
2-5. BELLY-BUTTON SWITCH GUARD.
The belly-button switch guard minimizes the possibility
of the driver being pinned by the steering arm while
driving the lift truck in reverse. If the guard presses
against the driver while the lift truck is being driven in
reverse, the guard actuates a switch which changes
the direction of the lift truck to forward direction in low
speed.
2-6. STEERING ARM RETURN SPRING.
The steering arm return spring automatically raises the
steering arm to the upright position when the steering
arm is released. If the steering arm snaps up abruptly,
or does not return fully, the steering arm return spring
requires adjustment. Return truck to maintenance
group for adjustment.
2-7. LIFT/LOWER/STOP CONTROL.
The LIFT/LOWER/STOP pushbuttons on the platform
are used raise and lower the platform at a fixed rate of
speed.
Proceed as follows to raise and lower the platform.
1. If truck is equipped with a key switch, turn it to the
on position.
WARNING: Check the space above the mast and the
load to be sure that there is sufficient
room for raising the platform. Make sure
the load is centered and does not
exceed capacity.
1. To raise the platform, push in the LIFT button and
hold until lift carriage reaches desired lift height.
2. To lower the forks, push in and hold the LOWER
button until platform is at the desired height.
2-1. PARKING.
When finished with moving loads, drive truck to its
maintenance or storage area. Disconnect batteries
from TRUCK receptacle and connect to CHARGER
receptacle. Charge batteries as necessary. Refer to
battery care instructions, paragraph
3-3.
R6203