Push down on the unit to adjust the depth to the
bottom of the pan (Fig.2). Fits pans up to 3” deep.
Finish tightening thumb screw.
5.
6.
Fig. 1
Thumb Screw
SECONDARY PAN SENSOR
FOR METAL & PLASTIC PANS
INSTALL FLOAT SWITCH ON DRAIN PAN
(To ensure proper performance of product,
instructions must be followed.)
Disconnect power to unit at main panel.
Disconnect power to the low voltage thermostat
circuit.
Slide the float switch onto the side of the pan.
Lightly secure the float switch by tightening the
thumb screws (Fig.1). Do not over tighten.
1.
2.
3.
4.
WARNING: WORK SAFE, READ THIS!
FAILURE TO READ AND COMPLY WITH ALL WARNINGS,
CAUTIONS, INSTRUCTIONS PRIOR TO STARTING
INSTALLATION MAY CAUSE PERSONAL INJURY AND/OR
PROPERTY DAMAGE AND VOID WARRANTY.
This device must be installed in accordance with
manufacturer’s instructions. This installation must
be in accordance with all applicable local plumbing,
drainage, and electrical codes.
This device must be installed in accordance with
manufacturer’s instructions. This installation must
be in accordance with all applicable local plumbing,
drainage, and electrical codes.
Remove electric shock hazard — DISCONNECT
THE POWER BEFORE INSTALLING SWITCH to avoid
electrical shock and/or equipment damage. Do not
use on circuits exceeding 24 volts to avoid damage
to switch, shock, or fire hazard. Switch must be
connected to an isolated transformer with a max
rating of 30VAC, 8A, and 100VA.
In any installation where property damage might
result from inoperative switch due to a power outage,
back-up system(s) and/or alarm should be installed.
The switch must only be installed by a licensed
contractor or under the direct supervision of same.
The condensation pan must be properly maintained
after installation and remain free from foreign
objects, rust, or other obstructions that might
interfere with the proper operation of the float switch.
INSTRUCTIONS
